Auto Dialer Circuit
IntroductionIn this project we show that how we use the telephone as a electronics eye. With the help of landline phone we check and examine the position of the house automatically. In this logic we attach some sensor with the telephone and if there is any miss happening then telephone is automatic on and then circuit press the redial button of the telephone and then telephone dial the pre-dialed number. All these logic is to be divided into few parts.
Following Steps are:
- Sensor unit.
- Micro controller interface
- Switch on the telephone
- Redial the number
- Switch off the telephone line after sending the message
- Voice processor circuit IC ISPVP 2000
SENSOR UNIT.
In this sensor unit it is our choice , how many sensor’s we use , IN this project we use two sensor’s, In this project we use two electronics circuit with infra red sensor’s and fire alarm sensor.
negative voltage as a pulse to the microcontroller.
If we connect two sensor as a input to the microcontroller then we use same
After pressing the flash button, redial button and switch on the telephone line we switch on the memory ic. We use relay circuit to switch off/on hook the telephone line.
Telephone dialer circuit.
In this portion of telephone dialer circuit we use the telephone dialer circuit. For this we use one dtmf generator circuit to generate a dtmf tones from the circuit. For this purpose we use one DTMF generator circuit to generate a dtmf tones from the circuit. We connect one telephone keypad or push to on switches with this circuit. We use total 14 push to on switches with this circuit to dial the dtmf tones. Once we dial the number in the dialer circuit. Now when micrcontroller press the redial switch then circuit is on and redial the pre-dial number .
All the switches are connected to the pin no no 12,13,14,15,16,17,18. All the switches are connected in row and matrix combination including redial and flash switch.
Voice Processor circuit- In this project we also used voice processor circuit having 60 sec recording/playback functionality. We can save 8 voice tags in this IC.
Components required:
Ic 91214
IC IPSVP- Voice Processor
89S52- Mircontroller
Condensor Mic
Speaker
104 pf
push to on switches
.001 µf,0.1 µf,0.01µf
1µf,
220k,470k,4.7k,10k,
crystal 11.0592 MHz
3.38 MHz.
buzzer,
speaker 8 ohm
relay 12v 100 ohm
transformaer 6v 500mA
infrared Sensor,
Thermocouples
connecting wires
copper clad board