In this project we will make voting machine using fingerprint machine. We will use fingerprint module for this purpose is sim630. There will be keys for any data store and check vote casted by anybody.
In this project we will use finger print module to recognize person. After recognition it will give data to Microcontroller 89s52. Finger print is the better option as compare to other. Normally we recognize person with password or some other method. It’s the best security system. It helps to find out person identity and will display on LCD. We will use serial interface for communication between finger print module and Microcontroller . few commands required to communicate search database from module. Module itself programmed with ARM processor. Module also have fixed memory. So you don’t require external serial or parallel interface for memory. We will use push to on switches to enter data. First of all we will add our thumb expressions. If all added, then there will be switch to search all. We will also use a key to delete all finger prints.
Applications:
Electronics voting machine
Access control using person recognition
Attendance system
In this project we
Technical Specifications
Operating Voltage:
4.3V~6V
Rating Voltage:
6.5V(exceeding this value will cause permanent damage to the module)
Operating Current:
<80mA(Input voltage 5V)
Fingerprint Template:
768 templates
Search Time:
<1.5s(200 fingerprint, average value in test)
Power-on Time:
<200ms(Time lapse between module power-on to module ready to receive
instructions)
Tolerated Angle Offset:
±45°
User Flash Memory:
64KByte
Interface Protocol:
Standard serial interface (TTL level)
Communication Baud Rate:
57600bps
Operating Environment:
Temperature: -10℃~+40℃
Relative humidity: 40%RH~85%RH(no dew)
Commands
Component list
Finger print module sim630- 1nos.
10 k resistor- 20 nos.
89s52
Connectors
Relay
BC548 and BC558- 4nos.
LEDs- 10 nos
LCD 16*2- 1nos.
Microswitch for keypad
Preset 10k
Resistors- 10k, 1k, 4.7k
Capacitor
Crystal- 22 Mhz