Objective
- To make a Secure distribution of electricity.
- To make a system, in which, whenever a fault occur in the primary side it will automatically cut off the further supply and will not activate the devices till the time the issue has not been resolved.
Introduction
In this project we are making system by which we can make electricity distribution system more safe and more secure and we can save the energy as well. In this project we are using current transformers to measure the emf readings of the current passing through it. These readings are given to the Arduino controller so that it can take the necessary actions according to the requirements. If there will be an fault at the primary end of the supply the secondary side will automatically gets cut off. The arduino will not activate the devices till the time the primary fault has not been solved. As soon as we resolve the primary fault, the arduino will start feeding the up the electricity to the secondary side also.
Material Required
Arduino atmega328
Relay 12 volts
Current Transformer
Bed switches
Bulb holder
Socket
Electrolytic capacitor 10 mfd/63 volts
Potentiometer 10k
Carbon resistors
Diodes 4148
Electrical Wire
Electrical Tape